Layout cell width

How can I change the width of a layer cell? When I change the
width value I get an error message saying the cell will be smaller
than the minimum width allowed. I'm guessing I have to go back and
reset some page properties but have't figured out how.



Layout cell width
The correct way would be to use css to allocate a width.
However, let the

width be determined by whatever is inside it. If you set the
width to

100px, but place an image inside the cell that is 120px, then
the cell will

stretch to fit that image, it will not honour the 100px
width. This would

also apply whether you specified a width via a stylesheet.





--

Nadia

Adobe庐 Community Expert : Dreamweaver

----------------------------------------

CSS Templates |Tutorials |SEO Articles


http://www.DreamweaverResources.com

~ Customisation Service Available ~


http://www.csstemplates.com.au

----------------------------------------



''griehund'' %26lt;webforumsuser@macromedia.com%26gt; wrote in
message

news:f1g6j3$bs$1@forums.macromedia.com...

%26gt; How can I change the width of a layer cell? When I
change the width

%26gt; value I

%26gt; get an error message saying the cell will be smaller
than the minimum

%26gt; width

%26gt; allowed. I'm guessing I have to go back and reset some
page properties

%26gt; but

%26gt; have't figured out how.

%26gt;

%26gt;

%26gt;





Layout cell width
Thanks a million,

I had to check the images in the other layout cells and found
some that were too large. After downsizing my header image
everything else fell into place.

Cliff


Flatus The Elder